I have a 500GB HDD which I was using as my primary HDD
I have now installed a 2nd 250GB which is absolutely blank
As soon as I connect the 250GB HDD, I dont get the option of choosing the 500GB HDD as the Booting option during setup.
It shows only the option of 250GB HDD
The 500GB Drive is visible under HDD option in the setup but not under booting sequence
If i just remove the power from the 2nd HDD, I can boot normally from the 500GB HDD.
My entire setup is given in my signature
What am I doing wrong?
I didn’t find the right solution from the Internet.